Ultra Start 33xx Series Instalační příručka

Procházejte online nebo si stáhněte Instalační příručka pro Vzdálené spouštěče Ultra Start 33xx Series. Ultra Start 33xx Series Install guide Uživatelská příručka

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 24
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 0
INSTALL GUIDE
www.ultrastarters.com
Technical Support: 866-698-5872 ext 0
support@ultrastarters.com
Covers All 32xx and 33xx Series
Advanced 2-Way Remote Starters
The system must be placed into Service Mode before any service work is started on the
vehicle. It is the sole responsibility of the vehicle owner to ensure that this is done. The
manufacturer accepts no liability or responsibility for accidental starting of the vehicle.
CARBON MONOXIDE - Never Start in an Enclosed Building (Garage, Carport etc...)
- The Hood Pin Safety Switch Must Always be Installed!
Warning!!
CARBON MONOXIDE MAY CAUSE SERIOUS INJURY, EVEN DEATH!
It is the sole responsibility of the user to place the system in Service Mode
when parking in an enclosed area ex: garage, partially enclosed area
ex: carport, or when the vehicle is being serviced.
Zobrazit stránku 0
1 2 3 4 5 6 ... 23 24

Shrnutí obsahu

Strany 1 - INSTALL GUIDE

INSTALL GUIDEwww.ultrastarters.comTechnical Support: 866-698-5872 ext [email protected] All 32xx and 33xx SeriesAdvanced 2-Way Remote S

Strany 2 - Table of Contents

Step 1 - Connect All Of the Following WiresINSTALL MANUAL REMOTE VEHICLE STARTER PAGE 10M

Strany 3 - Feature List

REMOTE VEHICLE STARTER INSTALL MANUAL

Strany 4 - PAGE 4

IMPORTANT! The system must be Tach Learned before remote starting. The Auto Tach Learn is the same for the TL (tachless) series.1) Turn the ignition k

Strany 5

Tach Learning the remote starter is one of the most important steps in the installation process. Do not tach learn vehicle while the engine is in high

Strany 6 - Wiring Diagram

1) With the ignition in the OFF position, turn the ignition key from “Off” to “On” 3 times, ON-OFF-ON-OFF-ON within three seconds. NOTE: Leave

Strany 7

Menu 1 - Press 1 Flash 2 Flashes 3 Flashes1 Ignition Lock Enabled Lo

Strany 8 - Wiring Descriptions

Setting 1 Ignition Auto Lock1) Enable 1 Flash/Honk Doors Lock/Unlock with Ignition key.2) Ignition Lock Only

Strany 9

Setting 1 Secure Valet Mode (time required to set the system into Service Mode)1) Secure Valet 1 Flash/Honk Hold the Program

Strany 10 - Important!

Setting 1 Special Door Lock/Unlock Operations (Factory Alarm Rearm).1) Type 1 1 Flash/Honk Unlock before start. Lock pulse after s

Strany 11 - INSTALL MANUAL

Setting 4 Run Time1) 4 Minutes 1 Flash/Honk Runs for approx. 4 minutes when activated.2) 45 Minutes 2 Flashes/

Strany 12 - Auto Tach (Tachless) Learn

Table of Contents Page 2Component/Feature List

Strany 13 - Important Tach Notes

Setting 1 Low Idle Learn- Same function as doing the Quick Tach Learn.This option is used for vehicles that maintain a High or Erratic idle after st

Strany 14 - button

REMOTE VEHICLE STARTER INSTALL MANUAL

Strany 15 - Quick View Programming

87868587a3087868587a30LockUnlockVehicleLock/UnlockSwitchTo Control Relay or ActuatorGreenFused +12VBlueGroundNegative Type Door Locks 250maNegative Do

Strany 16 - Menu 1- User Settings

87868587a3087868587a30BlueGreenLockUnlockVehicleLock/UnlockSwitchTo ActuatorFused +12VxxCutCut87868587a30GroundDIAGNOSTICS1387868587a3087868587a30Blue

Strany 17 - Menu 2- Additional Settings

If the remote starter does not activate when the start button is pressed the park lights will flash a diagnostic to indicate what shutdown input has b

Strany 18

Feature List- Control module - 6 pin Main harness- Antenna with built in - 14 pin auxiliary harness

Strany 19 - - continued

Recommended Installation ProceduresRemote car starters and alarms should be professionally installed. Review the installation and owner manuals and ac

Strany 20 - button for

Recommended Installation ProceduresMounting The Control Module - Never mount the module in the engine compartment. Select a location under the dash t

Strany 21 - Remote Transmitter Learn

Wiring Diagram1155332244661234567891011121314YELLOWYELLOWPURPLE**BLUE/WHITE***GREENRED/WHITEWHITEBLUEREDBROWNGREEN/WHITEREDORANGEGREEN**WHITE*WHITE/BL

Strany 22 - PAGE 22

ACTIVE RF ANTENNA**1 2 3NOTE: The jumpers control the output from the WHITE wire on the main 6- pin harness. This is an 30a

Strany 23 - DIAGNOSTICS

Wiring DescriptionsMAIN CONNECTOR (6pin) Pin Function Description1-YELLOW Starter Output -

Strany 24

Wiring Descriptions Pin Function Description9-GREEN/ Hood Pin(-) - Input to detect ground whe

Komentáře k této Příručce

Žádné komentáře