Ultra-start 1150 Series Uživatelský manuál stáhnout pdf (Strana 3)

REMOTE VEHICLE STARTER

INSTALLATION MANUAL

Page 3

The jumpers control the output from the white wire from the six pin

harness. Place the jumpers in the following order to change the output.

Note: The default setting is second ignition.

* Connect only one of these wires for remote start activation. The input requires 2

pulses within 2 seconds to activate.

Positive Start Trigger*

Negative Start Trigger*

Not used on this model

Negative When Running

Not used on this model

N/A

Program LED/Switch

1 2 3 4 5 6 7 8

Žádné komentáře

Ultra-start 1150 Series Uživatelský manuál Strana 3